PRE-ORDER X-Head Cylinder Protectors for BMW R1250GSA and R1250GS by MachinArt Moto The new X-Head 1250 cylinder head guards for all 2019+ Shift Cam engine models continue the Tough Polymer protective technology that's been successfully proven in use over three generations of X-Heads. Designed for the GS, GSA, RT, R, and RS, X-Head's thick, high impact strength injection molded shell is slightly ductile to prevent breakage. In between the shell and the cylinder head is a thick thermoplastic rubber liner that aids in dissipating impact force while preventing hard contact. Each side mounts easily with 3 stainless steel M5 T25 Torx Head screws provided. X-Head 1250 covers 70% of the face of the head to protect not only the bottom/front initial impact area, but also the mid part of the cylinder head. Even in a stationary drop, inertia can cause a bike to roll partially onto the face of the head before it settles down. X-Head 1250 are styled to complement the Shift Cam engines and fit perfectly with BMW's crash bars. For off-road riding they fill the vulnerable spaces in-between the bars to protect heads from rocks and strike angles on terrain that can get past the crash bars. Fitment with aftermarket brands of crash bars may vary, depending on the amount of clearance available between them and the cylinder head surfaces. To install X-Heads on bikes already fitted with crash bars, the bars will have to be removed to provide enough working room for X-Head installation. It is a straightforward bolts off, bolts on procedure. X-Head 1250 are here to protect - and look good in the process! |