Adjustable 2 Inch Pivoting Risers for BMW R1250GS/A and R1200GS/A Liquid Cooled MADE IN USA

ROX Adjustable 2 Inch Pivoting Risers for BMW R1250GS/A and R1200GS/A Liquid Cooled. MADE IN USA

Ready to replace your OEM clamping caps? You'll love our ROX adjustable 2-inch pivoting risers designed especially for the R1200GS/A and R1250GS/A liquid-cooled. These bikes have bars with a thicker diameter than any other BMW bikes, which the pivoting risers are specially designed to fit. These American-made pivoting risers for BMW bikes are compatible with all stock cables and brake lines, and they're sturdy enough to handle anything you can throw at them. With a clear anodized finish and custom caps, these risers are just what you need to make your bike run like the well-oiled machine it was designed to be.

These ROX 2-inch pivoting risers for BMW R1200GS/A and R1250GS/A liquid-cooled bikes have a 2-inch rise because OEM caps are too tall to work effectively. You can use your OEM bolts with these pivoting risers, which makes the replacement process simpler and faster. Don't get stuck with equipment that doesn't work as precisely as it should; swap out your OEM risers for these sleeker, better models.

To Install:The installation process is very straightforward. Here are the tools you will need:

• T45 Torx Bit
• 6 mm Hex Allen
• Ratchet

Begin by laying a towel down over the tank. Use the T45 and the ratchet to remove the handler bars from their mount. Rest the handle bars down against the towel so you can work with your hands free. Mount the risers on the bike without tightening. Attached the handle bars to the risers and then tighten everything.

Works with Stock Cables — see the manufacturers cable rerouting instructions below. ***COPY AND PASTE INTO A NEW BROWSER TAB
https://cdn.shopify.com/s/files/1/0735/5123/t/2/assets/bmw-reroute.pdf

Features:
- Allows the rider to adjust and find the ideal arm and shoulder position for him/herself
- Enable the rider to quickly adjust the riser pivot angle for on road and off-road standing riding position
- Proudly made in the U.S.
- Anodized Clear
- Patented by the U.S. Patent and Trademark Office under U.S. Patent #6,920,806.

NOTE: Always check and confirm that your vehicle has an adequate cable and brake line length before installing any handlebar risers.
To Use:

The best position for street riding is rocked back, while the best position for dirt riding is rocked up.